Millipore Polysep II

Listing description

Filter, 10" code 7 element; pack of 3. CGW671S03. 0.5 micron, nominal. Sealed in original packaging.
Description: Polysep II Cartridge Filter 10 in. 0.5 µm Code 7

Trade Name: Polysep

Support Material: Spun bonded polypropylene

Diameter, cm (in): 7.1 (2.8)

Sanitization: 30 min with hot water @ 80 °C

Nominal Pore Size, µm: 1.0 + 0.5

Packaging: Double Easy-Open bag

Filtration Area, m2: 0.46

Format: Double Layer

Configuration: Cartridge Filter

Cartridge Type: Liquid

Gravimetric Extractables: =140 mg after 24-h soak in water

Prefilter Material: Borosilicate glass microfiber

Cartridge Code: Code 7 (2-226) O-rings w/locking-tabs and spear

Wettability: Hydrophilic

Cartridge Nominal Length, in (cm): 10 (25)

Max Differential Pressure, bar (psid): 3.5 (50) @ 25 °C

Seal Material: Silicone

Bacterial Endotoxins: <0.5 EU/mL as determined by the LAL test

Filter Material: Mixed Cellulose Esters

Oxidizable Substances: Will meet the USP Oxidizable Substances Test requirements after a water flush of =5 L

Sterilization: 10 autoclave cycles or SIP @ 121 °C for 30 min

Device Material: Polypropylene

The Polysep™ II media consists of a borosilicate glass layer and a layer of mixed esters of cellulose membrane. The depth of the microfiber filter layer provides high particle loading capacity, and retention of large particulates while maintaining high flow rates. The mixed cellulose ester membrane layer provides the high retention needed during critical prefiltration steps while protecting more expensive downstream filtration devices and equipment.
Polysep II filters are available in four pore sizes, and multiple configurations that vary by filtration area and the type of connection.

This equipment is located in US