-
Machinery
Choose from 20,437 used machinery listings
- Auctions
- Sell machines
- Sell complete plants
- What is Kitmondo?
- About us
- Blog
1996 Feeler FV800A
Control: Fanuc 0M
Condition: Excellent
Under Power: Yes
Table:
Size: 16.7" x 37.4"
X-Axis Travel: 31.5"
Y-Axis Travel: 17.7"
Z-Axis Travel: 19.9"
Spindle:
Spindle Speeds Minimum - Maximum: 8,000 RPM
Spindle Taper: CT 40 Taper
Main Motor (30 min. / cont.): 7.5 HP
Tool Changer:
Tool Changer Positions: 20 ATC
General:
Electrics: 220 Volts
Equipped With:
Fanuc 0M Control
High Torque Spindle Motor
Assorted Tool Holders
Comment:
New Spindle Installed (200 hours of use since)
Loading on to waiting truck is included
Machine is in good condition with new spindle (not rebuild) with very few hours (less than 200) on it. Machine wasn't crashed but I was unaware at the time that belville washers in the spindle could go bad and had a tool holder start to pull out of the taper during a heavy cut. It tore up the taper and to get rush rebuild service was going to cost as much as a new spindle, which the manufacturer had on the shelf. So, I opted for the new spindle
I had purchased the machine and fixtured it to run selected ops on aluminum castings I was running for a customer that no longer exists. The machine has always been stored in heated space and can temporarily be put under power as necessary. No accessories that I can think of and it's located at my shop.
Business volume never came back to the point that I wanted to move it back in the main part of the shop and replumb, rewire, etc.
This equipment is located in US
Manufacturer | Feeler |
Model | FV800A |
Year | 1996 |
Country | USA |
Condition | Good |
Main category | Metalworking Machinery |
Subcategory | Machining Centre |
ID | P80907103 |
Client type | Machinery dealer |
On Kitmondo since | 2008 |
Number of listings | 70 |
Country | USA |
Employees | 1 - 10 |
Established | 2001 |
Last activity | March 15, 2024 |