Gullco GK-200-RMAO AND

Listing description

Plus a SELECTION OF USED GOOD QUALITY WELDING TRACTORS SHOWN BELOW
Carriage complete with heavy-duty self-aligning wheel assemblies. Carriage controlled by Gullco microprocessor based 24 volt D.C. programmable control
With closed loop tack feedback for accurate speed control when running in any plane regardless of load
Maximum 100 lbs. (45 kgs.). The carriage is controlled by the Gullco low voltage 24 volt GSP microprocessor pulse width modulation motor control interfacing with the forward/stop/reverse switch,
High speed return and infinitely variable 4-turn speed potentiometer. The LED display is in IPM or cm/min.
The carriage incorporates the oscillator electronic controls providing independent dwells at each end and the center of stroke, infinitely variable 0 to 5 seconds, oscillation speed potentiometer,
Speed range 8 to 188 cycles per minute (16 to 376 passes per minute).
Automatic wire feed start, adjustable carriage delay start, adjustable 0 to 3 seconds, dwell on/off switch, auto start switch, toggle switch to change oscillator mode from standard angular oscillation
Pattern to step square wave oscillation pattern.
Mains supply 42,110 or 220 volts
Complete working order and fully serviced condition
Package Includes:

4 months warranty

This equipment is located in GB