HAAS VF-6

Listing description

Vertical Machining Center – Haas, VF-6

Date of Mfg: 4/1996
Electrics: 208-230 Volts / 3 Phase / 50-60 Hertz
Full Load Amps: 20
Largest Full Load Amps: 30
Short Circuit Interrupting Capacity: 10,000 Amps
Hours: 6,600
X-Axis: 64?
Y-Axis: 32?
Z-Axis: 30?
Spindle Nose to Table Max: 34?
Spindle Nose to Table Min: 4?
Table: 64? x 28?
T-Slot Width: 5/8 ”
T-Slot Center Distance: 4.92?
Number of Std T-Slots: 5
Max Weight on Table: 4,000 lb
Max Rating: 30 HP
Max Speed: 8,100 RPM
Taper: CT or BT 40
ATC: 24+1
Features:
…Wired for 4th and 5th Axis (5th axis was in use.)
…Comes with trunnion table
…15 HP Motor
…10,000 RPM
…Coolant through Spindle
…Comes with 8-10 mill holders that were in carousel at time of disconnect (70-80% aluminum / 30% steel alloys).

Notes:
…Two slots do not work in carousel during tool change function.

Equipment is NOT under power; available for inspection.
Buyer responsible for freight logistics and expenses.
Seller agrees to load equipment on Buyer’s transportation.

This equipment is located in US