Microfor FP1-ED Microfor FP1-ED

Listing description

https://www.posalux.ch/site/en/products/microfor_edm/fp1_edm

The last µ-EDM developments allow short cycle time, repeatability and stability on any conductive material without alteration.

Micro Machining:

Hole diameter from 50 µm to 2 mm (0.002 to 0.08 inch)
Reverse taper up to 150 µm/mm
On any conductive material
Without burr and material deposit
No micro-crack
Excellent surface texture: Ra< 1 µm

This equipment is located in SG